Hello all,
so finally I have found my problem source - it was thermistor wiring, cable was broken from bending by carriage movement :-(
I will upgrade my Marlin release too, the only problem is, that somebody already programmed code for run of filament detection, which I already have for a long time, so I will need to compare both new and my old code to rewrite my function into new version.
Regards!
O.C.
so finally I have found my problem source - it was thermistor wiring, cable was broken from bending by carriage movement :-(
I will upgrade my Marlin release too, the only problem is, that somebody already programmed code for run of filament detection, which I already have for a long time, so I will need to compare both new and my old code to rewrite my function into new version.
Regards!
O.C.